Vectorworks Tips 445 – Clip Cube Viewport

clip cube viewport

I saw someone on the community board ask if it was possible to use the click cube to create a perspective viewport. It is possible. There are a few steps involved in this:

  1.  Use the Clip Cube to create a section viewport.
  2.  Place the section viewport on a design layer.
  3.  Use a camera to create the required perspective view.
  4.  Create a viewport from this design layer in place of the standard viewport on a sheet layer.

 

Vectorworks Tip 437 –  Creating A Viewport That Fades Out

Vectorworks-Tip-437

I saw on the tech board, somebody was asking for a technique that would allow the viewport to fade out. I think you can achieve this now if you put an object in your viewport with a transparent gradient. In the image you can see I created a gradient that changes from solid white to transparent. I used the attribute mapping tool to control where the transparent and solid parts are, and I also used the attributes palette to change the gradient from a linear gradient to a radial gradient.