Architect_058 Architect Special Interest Group November 2014 (pm)

image064In this session we looking in detail at how to set up a wall style that uses Design Layers, Levels and Stories to control the elevations of the wall components and how to connect the wall components to slab components.


  I have created some extremely effective content, but you have to be a member to see it, sorry. Please become a member so that you can access this content.

One thought on “Architect_058 Architect Special Interest Group November 2014 (pm)

  1. Hi, towards the end Tony had an issue with a section of wall below the insulation. Would it be easy to create the deeper setdown in the slab and then just create a wall style and top bound -50 and bottom bound -172+50=222, to fill in the gap between the slab setdown and bottom of insulation.

    Thanks for this learnt a lot again.


Leave a Reply