Vectorworks Tip #153 – 3D Modelling – Deform Tool Posted on October 3, 2014 by jonathan The Twist tool that was introduced with Vectorworks 2014 has been replaced by a new Deform tool. This tool has a lot more ability than the tool it is replacing, allowing you to bend, bulge, taper and twist objects. Other Posts that Might be Of Interest Vectorworks Tip #141 - 3D Modelling – Project Tool 3The third mode of the Project Tool is quite different to the first two. In… Vectorworks Tip #145 - 3D Modelling – Fillet EdgeThe Fillet Edge tool from the 3D Modelling toolset is used around the corners of… Vectorworks Tip #079 - 3D Modelling - Twist ToolThis is a great tool for twisting your 3D objects. There are other ways to…