cadmovie437 – Saving a Corrupt File Part 1

Sometimes you find you can’t get the information from your Vectorworks file, or the file might seriously misbehave. I have a possible solution. This works most times, but not always. If this techniques doesn’t work, there is nothing else you can do, you have to go a backup copy of your file.

The way this technique works is that you create a link from the old file to a new, clean file using Workgroup Referencing. Then when you break the link all the linked information stays in the new file.

There is some great protected information here that is only available to paying subscribers. You must be an active paying subscriber to see it, but you can  Subscribe here.

Leave a Reply