Landscape Special Interest Group May 2017 pm

Landscape_may_2017_pm

In this session, we looked at creating a small, outdoor pergola seating area and its drawing details. This means that we had to look at how the footings were created, how the posts would be connected to the footings in detail, and how we would construct the posts, beams, and trusses in detail.

Continue reading

3D Modeling Special Interest Group – May 2017

3D_Modeling_may_2017

In this session, we looked at creating a tapered extrude for a table leg, creating quicker viewports from objects, creating a custom sketch style for a drawing, using the Fillet tool, and creating a Queen Anne style table leg.

Continue reading

Getting Started Special Interest Group May 2017

Gettting Started Special Interest Group May 2017

In this session, we looked at creating a specific door and window combination by using the window plugin available in Australia and New Zealand (Windoor). We also looked at basic Vectorworks geometry and how to recognize the difference between X, Y, and Z. This led to a discussion about the screen plane, working plane, and layer plane.

Continue reading

3D Modeling Special Interest Group – January 2017

3D_Modeling_Jan_17

This session is not a beginner session on 3D modelling, it is an intermediate/advanced session. We covered the concept of meshes, modelling history, generic solids, and a small amount of basic 3D modelling. The users wanted to look at how we could use the history of the 3D modelling to change objects.

Continue reading