SST_1609 – Quick Concept Modeling

cover-imageVectorworks has the tools and commands to quickly create a concept model. But we want mode than just a few elevations, we need to know if the main site can be subdivided, how large the project can be, and how much it might cost to construct.
In this manual we will be looking at ways to create and visualise the concept. We will start by creating the site, then the site model, create the adjoining buildings, create the design, and set up solar studies.

Table of Contents

Introduction

  • Document Set up
    • Creating A New File
    • Setting Up The Page Size
    • Setting Up The Drawing Units
    • Setting Up Layers
    • Setting Up Classes For The Concept
  • Importing the Site Plan
  • Creating The Site Plan
  • Creating Reports
  • Creating Existing Areas Report
  • Creating Proposed Areas Report
  • Creating A Budget Report
  • Creating Adjoining Buildings
  • Creating A Camera View
  • Creating A Sun
  • Creating A Solar Study
  • Conclusion
There is some great protected information here that is only available to paying subscribers. You must be an active paying subscriber to see it, but you can  Subscribe here.

 

Leave a Reply