cadmovie1604_06 – Subdivision Modeling – Part 6

Face Extrude Mode

This mode is ideal for adding apart to your model by extruding a face. If you have used Push/ Pull tool, then you might be familiar with the concept of extruding a face. When using this concept with subdivision surfaces, the results can be slightly different, but the concept is still the same: the extruded face mode will extrude the face of the object perpendicular to the plane of it.

There is some great protected information here that is only available to paying subscribers. You must be an active paying subscriber to see it, but you can  Subscribe here.

Previous cadmovie

Next cadmovie

Leave a Reply