Landmark_SIG_069 Special Interest Group March (pm) 2015

This session looked at 3D modelling, creating a tent sail & posts & deck steps using NURBS modelling, Loft Surface tool, Project tool, 3D Polygon tool, Convert to NURBS command, Extrude Along Path (Uniform & Exponential) commands, Offset tool, Create Objects from Shapes (into Floor and Hardscape) command. It also covered creating two deformed columns using the Regular Polygon tool, Push/Pull and Deform (taper & twist) tool, Shell Solid tool plus editing existing textures (adding a transparency) to suit. In the process the topics also covered were: Orthogonal View, Z key, B key, Clip Surface tool, Rotate tool, Move by Points tool, Walkthrough, Subtract Solids command, Extract (Surface) tool & Unfold Surfaces command.


There is some great protected information here that is only available to paying subscribers. You must be an active paying subscriber to see it, but you can  Subscribe here.

Leave a Reply