Architect_067 Architect Special Interest Group April 2015(am)

Screenshot 2015-04-14 at 19.23.30This session focussed on when to make a break from the 3D model to 2D drawings. The discussion started as we were discussing what to cover in this session. It was a great example of needing to be at the session to get the best from it. We did start the recording and go back over most of the important parts of the discussion, so you can see most of the discussion in this movie. We covered the Detail Viewport command, when you can use it, and when you can’t. There are times that the Detail Viewport cannot place the detail references where you want them, and time when it can.

There is some great protected information here that is only available to paying subscribers. You must be an active paying subscriber to see it, but you can  Subscribe here.

Leave a Reply