Education_002 – New Ways of Drawing

New Ways of Drawing

When you are drawing on your drawing board or even in some CAD programs, you draw with lines (lines, circles and arcs). The tendency is to carry the same practice on when you use VectorWorks.

There is some great protected information here that is only available to paying subscribers. You must be an active paying subscriber to see it, but you can  Subscribe here.

This drawing was created using traditional drawing methods. To draw this took me about 27 mins, the first time I drew it.

This drawing was created using 3D Modeling and drawing methods. To create this took me about 7 mins, the first time I drew it.

 

Previous Page: Introduction to CAD

Next Page: Introduction to Vectorworks

©Jonathan Pickup 2013

Leave a Reply